AXIAL CAPRA 1.9 UNLIMITED Brass front/rear gearbox cover by GPM CP012AX  [CP012AX]

Brass front/rear gearbox cover for CAPRA 1.9

This is an RC-scale brass front and rear gearbox cover set designed for the AXIAL CAPRA 1.9 UNLIMITED chassis. The kit is a 5pcs set that combines a precision-machined brass cover with the supplied stainless steel cap head screws, intended to protect the front and rear gearbox housings and add rotational mass to help stabilize the differential under low-speed technical driving.

The cover is cast/machined from brass and the assembly weight listed in the source is 67 grams for the included parts, providing a deliberate weight bias useful for tuning traction and balance on scale trail rigs. Fitment is specified for the AXIAL CAPRA 1.9 UNLIMITED chassis only, treat this as an RC accessory when planning suspension and driveline setup changes.

Installation requires removal of the stock gearbox cover and careful re-use or replacement of sealing elements if present. Tighten the supplied 2.5x16 stainless steel cap head screws to factory torque levels for small-scale RC hardware to avoid stripping or misalignment, and verify differential rotation after fitting to confirm proper mesh and bearing alignment.

Use this brass cover set when you want a durable replacement that also alters mass distribution for tuning purposes on an AXIAL CAPRA 1.9 UNLIMITED scale trail rig; confirm screw torque and gear mesh after fitment and monitor differential behavior during initial runs.