Futaba 6EXAP 6-Channel FM 40MHz/ R136F  [6EXAP_c2]

QUALITIES:

• Aileron, Elevator and Rudder double price switch - utilize this switch to flip between two aileron, elevator and rudder control throw settings. The throws could be setup however prefer, but generally, whenever switch is up the throws are greater (higher rate) when the switch is down the throws are less (low rate). This switch also flips between exponential prices (if utilized).
• Flap control dial/Channel 6 - This dial runs the servo attached to channel 6 into the receiver should your model has flaps this is actually the control used to operate them.Aileron/elevator control stick -Mounting point for optional neck band.
• Trim levers (all) -Used to move the basic or center place of each servo as labeled in diagram.
• Recharging jack - Port for charging the transmitter batteries aided by the included battery charger.
• On-off switch
• DATA INPUT lever - regularly change the values of this different functions presented in the LCD screen.
• Liquid-crystal screen (LCD) - shows development modes and values entered.
• MODE key - accustomed scroll through and show the ten or eleven(PCM) various functions.
• CHOOSE key - always display the values for the current function.
• Throttle-cut switch - to make use of the throttle-cut function, lower the throttle stick all the way, then drive the throttle-cut switch to completely shut the carburetor and shut associated with the motor.
• Throttle/rudder control stick - Operates the servos connected to channel 3 (throttle) and channel 4 (rudder) in receiver.
• Trainer switch - Operates the trainer functions. To operate as a trainer switch the transmitter must be linked to another transmitter via. a trainer cable (available individually).
• Retractable landing gear switch/Channel 5 - change runs the servo connected to channel 5 in the receiver if the model has retractable landing gear this could be the control always extend and retract the apparatus.
• Antenna - Radiates signals on receiver. Never fly a model without fully extending the antenna or perhaps you may produce disturbance with other modelers and decrease operational signal array of the
• transmitter. The antenna might removed and replaced with another in the event it is inadvertently broken.

INCLUDES:

• Futaba 6-Channel 6EXAP transmitter
• Futaba R136F Receiver
• Change Harness
• Handbook

SPECS:

Transmitter

• T6EXAP Transmitter with programmable mixing and 6-model memory.
• Transmitting on 40 / 72 MHz musical organization.
• Operating-system: 2-stick, 6-channel system
• Modulation: FM(PPM) and PCM
• Power: 9.6V NT8S600B Ni-Cd battery or 12V alkaline battery pack
• Present drain: 250mA

Receiver

• R136F narrow band, FM 6 channel receiver.
• Receiving on 40 / 72 MHz musical organization.
• Type: FM, Dual conversion/FM, Single conversion
• Intermediate frequencies: 455kHz, 10.7MHz/455kHz
• Power requirement: 4.8V or 6V
• Present drain: 9.5mA @ 4.8V
• Size: 1.31 x 1.98 x 0.71" (33.4 x 50.3 x 18.1mm)
• Weight 0.98oz (27.8g)