Futaba 6EXAP 6-Channel FM 72Mhz/ R156F  [6EXAP_c13]

Price:
USD$115.00
Brand:
Futaba
Model:
6EXAP_c13
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
R/C Models - System - Transmitter - Flight Transmitters category
Write a review
QUALITIES:
  • Aileron, Elevator and Rudder twin rate switch - utilize this switch to ��flip�� between two aileron, elevator and rudder control throw settings. The tosses are setup however prefer, but generally speaking, if the switch is ��up�� the throws are greater (��high rate��) and when the switch is ��down�� the throws are less (��low rate��). This switch also flips between exponential rates (if utilized).
  • Flap control dial/Channel 6 - This dial operates the servo connected to channel 6 in receiver if your model has flaps this is actually the control used to use them.Aileron/elevator control stick -Mounting point for optional throat strap.
  • Trim levers (all) -Used to shift the neutral or center place of each and every servo as labeled in the diagram.
  • Billing jack - Port for charging you the transmitter batteries with the included battery pack charger.
  • On-off switch
  • DATA INPUT lever - always replace the values of this various functions presented on LCD display screen.
  • Liquid-crystal display (LCD) - shows programming modes and values joined.
  • MODE key - accustomed scroll through and display the ten or eleven(PCM) different functions.
  • CHOOSE key - accustomed show the values for the present function.
  • Throttle-cut switch - to make use of the throttle-cut function, reduced the throttle stick entirely, then Push the throttle-cut switch to fully close the carburetor and shut associated with the engine.
  • Throttle/rudder control stick - runs the servos connected to channel 3 (throttle) and channel 4 (rudder) within the receiver.
  • Trainer switch - Operates the trainer functions. To work as a trainer switch the transmitter should be linked to another transmitter via. a trainer cable (available individually).
  • Retractable landing gear switch/Channel 5 - Switch operates the servo attached to channel 5 in the receiver when your model has retractable landing gear this is the control always extend and retract the gear.
  • Antenna - Radiates signals to your receiver. Never fly a model without fully extending the antenna or you may create interference with other modelers and decrease operational signal selection of the transmitter. The antenna may be removed and replaced with another just in case its inadvertently broken.

Copyright © 2008-2024 rcjaz.com All rights reserved


Merry Deals for Every Hobbyist!
Redeem [ XM03 ] for 3% OFF—no minimum required!
Use [ XM05 ] for 5% OFF on orders over $100!
Go big with [ XM10 ] for 10% OFF on orders over $200!
This Christmas, gift your hobby the savings it deserves!