Futaba 6EXAP 6-Channel PCM 35Mhz/ R136HP/ 4xS3003 [6EXAP_c7]

Price:

USD$189.00

Brand:

Futaba

Model:

6EXAP_c7

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the
R/C Models - System - Transmitter - Flight Transmitters category

Write a review

Description

QUALITIES:

Aileron, Elevator and Rudder double price switch - utilize this change to ��flip�� between two aileron, elevator and rudder control throw settings. The tosses is create nevertheless choose, but generally, whenever switch is ��up�� the throws are greater (��high rate��) when the switch is ��down�� the throws are less (��low rate��). This switch also flips between exponential prices (if used).
Flap control dial/Channel 6 - This dial operates the servo attached to channel 6 into the receiver should your model has flaps this is actually the control used to operate them.Aileron/elevator control stick -Mounting point for optional neck strap.
Trim levers (all) -Used to move the basic or center place of every servo as labeled within the diagram.
Recharging jack - Port for recharging the transmitter batteries aided by the included battery pack charger.
On-off switch
INFORMATION INPUT lever - accustomed change the values of the various functions shown regarding the LCD display screen.
Liquid-crystal display (LCD) - Displays development modes and values entered.
MODE key - always scroll through and display the ten or eleven(PCM) different functions.
PICK key - always show the values for the present function.
Throttle-cut key - To use the throttle-cut function, lower the throttle stick entirely, then drive the throttle-cut key to fully close the carburetor and shut of engine.
Throttle/rudder control stick - runs the servos connected to channel 3 (throttle) and channel 4 (rudder) within the receiver.
Trainer switch - Operates the trainer functions. To work as a trainer switch the transmitter must be linked to another transmitter via. a trainer cord (available separately).
Retractable landing gear switch/Channel 5 - Switch runs the servo connected to channel 5 inside receiver in the event your model has retractable landing gear this is the control used to extend and retract the apparatus.
Antenna - Radiates signals to the receiver. Never ever travel a model without fully expanding the antenna or perhaps you may create interference to other modelers and decrease functional signal range of the transmitter. The antenna could be removed and changed with another in the event its unintentionally broken.

Hot Brands

Futaba 6EXAP 6-Channel PCM 35Mhz/ R136HP/ 4xS3003 [6EXAP_c7]