Futaba 6EXAP 6-Channel PCM 72Mhz/ R146IP  [6EXAP_c11]

Price:
USD$127.00
Brand:
Futaba
Model:
6EXAP_c11
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
R/C Models - System - Transmitter - Flight Transmitters category
Write a review
FEATURES:
  • Aileron, Elevator and Rudder twin price switch - utilize this change to ��flip�� between two aileron, elevator and rudder control throw settings. The tosses are create however prefer, but generally, when the switch is ��up�� the throws are greater (��high rate��) when the switch is ��down�� the throws are less (��low rate��). This switch also flips between exponential rates (if utilized).
  • Flap control dial/Channel 6 - This dial runs the servo attached to channel 6 into the receiver in case the model has flaps this is actually the control utilized to operate them.Aileron/elevator control stick -Mounting point for optional neck band.
  • Trim levers (all) -Used to move the neutral or center position of every servo as labeled in the diagram.
  • Charging you jack - Port for charging you the transmitter batteries with all the included battery charger.
  • On-off switch
  • DATA INPUT lever - always change the values regarding the different functions presented regarding the LCD display screen.
  • Liquid-crystal display (LCD) - shows programming modes and values entered.
  • MODE key - regularly scroll through and show the ten or eleven(PCM) various functions.
  • PICK key - Used to display the values for the current function.
  • Throttle-cut switch - to make use of the throttle-cut function, reduced the throttle stick completely, then Push the throttle-cut key to completely shut the carburetor and shut regarding the engine.
  • Throttle/rudder control stick - runs the servos attached to channel 3 (throttle) and channel 4 (rudder) in receiver.
  • Trainer switch - runs the trainer functions. To operate as a trainer switch the transmitter must certanly be connected to another transmitter via. a trainer cable (available individually).
  • Retractable landing gear switch/Channel 5 - Switch operates the servo connected to channel 5 into the receiver when your model has retractable landing gear this is the control accustomed expand and retract kit.
  • Antenna - Radiates signals towards receiver. Never travel a model without fully extending the antenna or perhaps you may produce disturbance to many other modelers and decrease functional sign array of the transmitter. The antenna could be eliminated and replaced with another just in case it is unintentionally broken.

Copyright © 2008-2024 rcjaz.com All rights reserved


Merry Deals for Every Hobbyist!
Redeem [ XM03 ] for 3% OFF—no minimum required!
Use [ XM05 ] for 5% OFF on orders over $100!
Go big with [ XM10 ] for 10% OFF on orders over $200!
This Christmas, gift your hobby the savings it deserves!