Tamiya 47480 - 1/10 M-08R Chassis Kit RWD  [47480]

The M-08R adds an array of race-spec components towards the balanced, compact RWD M-08 Concept chassis: an illustration being the hopped-up drivetrain with a ball differential, universal shafts featuring low-friction cross joints and lightweight aluminum swing shafts, plus 5mm wheel hubs. Turnbuckle shaft suspension system supply and steering setup components simplify fine-tuning of M-08R, and titanium-coated shafts are a durable addition in kit. Carbon fiber damper remains are combined with M-Chassis big bore aluminum dampers+ featuring dedicated blue anodized top and bottom caps for a touch of course, while a 20-gram ballast fat is roofed to obtain the chassis feeling so how you need it to.

Featured Elements

Drivetrain:

• Full ball bearings
• Ball differential (52T)
• 33mm lightweight aluminum swing shafts
• Cross joint for LF construction type universal shafts
• 06 module fluorine coated 20T pinion gear
• M-08 Concept aluminum shafts
• M-Chassis reinforced freewheel axles
• 5mm clamp-type wheel hubs

Suspension:

• Carbon dietary fiber damper stays (front/rear)
• Reinforced D components (suspension system arms)
• Aluminum turnbuckle shafts
• Titanium coated suspension system shafts
• 5x5mm, 5x11mm difficult hex mind ball connectors
• M-Chassis big bore aluminum dampers+
• 3x 1.3mm-hole pistons
• 4mm aluminum serrated wheel peanuts (blue)
• 5mm reinforced open face adjusters

Chassis:

• Carbon fibre battery holder
• Carbon fiber human body mount base
• Reinforced K parts (gearbox)
• Chassis stability fat (20g)
• Hi-torque servo saver
• Aluminum ball connectors (blue)
• Hex mind screws

Requirements

• Length: 319mm (with 225mm wheelbase), width: 165mm
• Alterable wheelbase: 210mm, 225mm, 239mm
• Monocoque framework with separate front and back sections
• Midship engine, rear-wheel drive
• Ball differential
• 3-piece steering tie-rod
• 4-wheel dual wishbone suspension
• M-Chassis big bore aluminum dampers+
• Gear ratio = 5.776:1 (using kit 20T pinion); 8 ratios between 6.795:1 and 4.813:1 are possible with individually sold pinions)
• Electronic rate controller (ESC) is sold separately.

Separately Needed Items

• Body
• Type 540 motor (brushless is recommended)
• Tires
• 2-channel R/C system w/ESC
• R6/AA/UM3 batteries for transmitter
• Battery pack & charger