TRAXXAS MAXX MONSTER TRUCK Stainless Steel Tie Rods and 25T Servo Horn with Adjustable CVD Drive Shafts by GPM TXMS1625123  [TXMS1625123]

Traxxas MAXX steering and driveline set

This 20pcs aftermarket set is an RC-scale steering and driveline replacement package designed for Traxxas MAXX monster truck use. The kit groups stainless steel tie rods, an aluminum 25T servo horn and front/rear adjustable CVD drive shafts to address steering linkage durability and driveline load transfer on hobby-grade vehicles.

Materials and form factor are chosen for wear resistance and serviceability: main link components use stainless steel for corrosion resistance, and the servo horn is machined from 6061-T6 aluminum to keep weight low while maintaining tensile strength. CVD swing joints replace older cross-pin designs to provide more consistent power transfer to the wheels under load.

Installation notes: tie rod length is adjustable by inserting a tool into the positioning hole and rotating the rod using clockwise and counterclockwise threads for fine alignment of knuckle arm angles. The servo horn uses a 25T spline interface and fasteners supplied in the kit; verify servo spline compatibility before fitting. The CVDs mount to existing drive cups and use supplied pins and screws for secure attachment.

This set is intended for hobbyists seeking a corrosion-resistant, adjustable steering linkage and stronger CVD-based driveline on Traxxas MAXX scale trucks; use as a direct replacement where spline and mounting interfaces match the stock components.